Ford 2012 F-250 Manuel d'utilisateur télécharger pdf (Page 144)

100

101

2. Press and hold control button 1

for five seconds. A tone will be

heard after two seconds confirming

memory position has been set.

Continue to hold until a second tone

is heard after five seconds.

3. Within three seconds press

4. Wait 10 seconds, then press .

5. Repeat this procedure for

memory 2 and another transmitter if

desired.

Deprogramming memory feature from transmitter

To deactivate this feature:

1. Press and hold either the 1 or 2 control on the driver’s door for five

seconds. A tone will be heard after 1

⁄

seconds when the memory store

is done, continue to hold until a second tone is heard after five seconds.

2. Within three seconds press

3. Repeat this procedure for another transmitter if desired.

Replacing the battery

The integrated keyhead transmitter (IKT) or intelligent access key (IA

key) uses one coin type three-volt lithium battery CR2032 or equivalent.

Integrated keyhead transmitter (IKT)

To replace the battery:

1. Twist a thin coin in the slot near

the key ring to remove the battery

cover (1).

Note: Do not wipe off any grease on

the battery terminals on the back

surface of the circuit board.

2. Carefully peel up the rubber

gasket (2) from the transmitter if it

does not come off with battery

cover.

3. Remove the old battery (3).

Note: Please refer to local regulations when disposing of transmitter

batteries.

Locks and Security

144

2012 F-250/350/450/550 (f23)

Owners Guide, 4th Printing

USA (fus)

1 2 ... 139 140 141 142 143 144 145 146 147 148 149 ... 447 448

Ford 2012 F-250 Manuel d'utilisateur Page 144

Commentaires sur ces manuels