Ford 2012 F-250 Manuel d'utilisateur télécharger pdf (Page 117)

Note: Make sure you keep the original remote control transmitter for

use in other vehicles as well as for future system programming.

Note: We recommend that upon the sale or lease termination of your

vehicle, you erase the programmed function buttons for security reasons.

See Erasing the function button codes later in this section.

Note: You can program a maximum of three devices. To change or

replace any of the three devices after it has been initially programmed,

you must first erase the current settings. See Erasing the function

button codes later in this section.

Note: Programming the system to a community gate will require a

unique set of instructions depending on the gate system model. Contact

the help line on 1-866-572-2728 for further information.

Note: If you accidently enter the program mode by pressing and

releasing the outer two buttons or all three buttons simultaneously, do

not press any button until the module times out after a few seconds and

resets to normal mode. When the module has timed out, all three LED

lamps will flash rapidly for a few seconds then turn off. Any settings

should remain as previously set.

The universal garage door opener

replaces the common hand-held

garage door opener with a

three-button transmitter that is

integrated into the driver’s sun visor.

The system includes two primary

features, a garage door opener and a

platform for remote activation of devices with the home. As well as being

programmed for garage doors, the system transmitter can be

programmed to operate security devices and home lighting systems.

Additional system information can be found on-line at www.learcar2U.com

or by calling the toll-free help line on 1-866-572-2728.

Types of garage door openers (rolling code and fixed code)

The Car2U威 Home Automation System may be programmed to operate

rolling code and fixed code garage door openers.

• Rolling code garage door openers were produced after 1996 and are

code protected. Rolling code means the coded signal is changed every

time your remote control garage door opener is used.

• Fixed code garage door openers were produced prior to 1996. Fixed

code uses the same coded signal every time. It is manually

programmed by setting DIP switches for a unique personal code.

Driver Controls

117

2012 F-250/350/450/550 (f23)

Owners Guide, 4th Printing

USA (fus)

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 447 448

Ford 2012 F-250 Manuel d'utilisateur Page 117