Ford 2012 F-150 Raptor v.3 Manuel d'utilisateur télécharger pdf (Page 138)

100

101

Cross bars: Aluminum cross bars with T-slot channels in all four sides,

and a latch mechanism that allows the end supports to snap over the

existing cleats. Cross bars are rated to hold loads up to 100 lb (45 kg)

load evenly distributed between the two crossbars, and the T-slots are

sized to accept industry-standard roof rack accessories.

• To remove cross bar, lift handle on each side and lift end support

shroud off of the cleat.

• To install cross bar, align cleats directly across from each other on the

same rail (upper or lower). Then place crossbar end support onto

cleat and press down on each side until the latch handle cycles up and

then press the handle down to secure (pull up on the bars to ensure

they are securely attached).

• To install accessories into T-slots, remove cross bar and turn upside

down, then find the slip joint end, indicated with an arrow embossed

on the bottom of the support. Using a T25 Torx driver, remove two

Torx head bolts from bottom, and slide end support off of aluminum

extrusion. Insert accessory into desired T-slot, and install end support.

When tightening Torx head bolts, hand tightening with a Torx driver is

sufficient, DO NOT over torque by using a ratchet.

Driver Controls

138

2012 F-150 (f12)

Owners Guide, 3rd Printing

USA (fus)

1 2 ... 133 134 135 136 137 138 139 140 141 142 143 ... 471 472

Commentaires sur ces manuels

Pas de commentaire

Ford 2012 F-150 Raptor v.3 Manuel d'utilisateur Page 138

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Ford 2012 F-150 Raptor v.3