Ford 2011 Crown Victoria v.1 Manuel d'utilisateur Page 24

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 331
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 23
Warning messages that have been reset are divided into three categories:
They cannot be reset until the condition is corrected.
They will reappear on the display 10 minutes from the reset.
They will not reappear until an ignition off-on cycle has been
completed.
This acts as a reminder that these warning conditions still exist within
the vehicle.
DOOR AJAR Displayed when a door is not completely closed.
POWERTRAIN MALFUNCTION Displayed when the powertrain is
not operating properly. If the warning stays on or continues to come on,
contact your authorized dealer as soon as possible.
COOLANT OVER TEMPERATURE Displayed when the engine
coolant is overheating. Stop the vehicle as soon as safely possible, turn
off the engine and let it cool. Check the coolant and coolant level. Refer
to Engine coolant in the Maintenance and Specifications chapter. If
the warning stays on or continues to come on, contact your authorized
dealer as soon as possible.
WARNING: Never remove the coolant reservoir cap while the
engine is running or hot.
CHECK FUEL CAP Displayed when the fuel filler cap is not
properly installed. Check the fuel filler cap for proper installation. Refer
to Fuel filler cap in the Maintenance and Specifications chapter.
CHECK AIR SUSPENSION Displayed when the air suspension
system is not operating properly. If this message is displayed while
driving, pull off the road as soon as safely possible. For more
information, refer to Air suspension system in the Driving chapter.
AIR SUSP OFF Displayed when the air suspension system is turned
off. For more information, refer to Air suspension system in the
Driving chapter.
FUEL LEVEL LOW Displayed as an early reminder of a low fuel
condition. Warning message can be reset by pressing the RESET button,
but will return after 10 minutes. If any other button is pressed besides
RESET, the message ’’PRESS RESET TO CLEAR’’ will appear in the
message center. Once this message disappears (after approximately two
seconds), press RESET to clear the warning.
Instrument Cluster
24
2011 Crown Victoria (cro)
Owners Guide, 1st Printing
USA (fus)
Vue de la page 23
1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 330 331

Commentaires sur ces manuels

Pas de commentaire