Ford 2009 Focus v.1 Manuel d'utilisateur télécharger pdf (Page 198)

WARNING: To lessen the risk of personal injury, do not put any

part of your body under the vehicle while changing a tire. Do not

start the engine when your vehicle is on the jack. The jack is only

meant for changing the tire.

6. Remove the lug nuts with the lug wrench.

7. Replace the flat tire with the spare tire, making sure the valve stem is

facing outward. Reinstall the lug nuts until the wheel is snug against the

hub. Do not fully tighten the lug nuts until the wheel has been lowered.

8. Lower the wheel by turning the jack handle counterclockwise.

9. Remove the jack and fully tighten

the lug nuts in the order shown.

Refer to Wheel lug nut torque

specifications later in this chapter

for the proper lug nut torque

specification.

10. Put the flat tire, jack and lug

wrench away. Make sure the jack is

fastened so it does not rattle when

you drive. Unblock the wheels.

TEMPORARY MOBILITY KIT (IF EQUIPPED)

Your vehicle may be equipped with a temporary mobility kit (located in

the spare tire well in the trunk). The temporary mobility kit consists of

an air compressor to reinflate the tire and a sealing compound in a

canister that will effectively seal most punctures caused by nails or

similar objects. This kit will provide a temporary seal allowing you to

drive your vehicle up to 120 miles (200 km) at a maximum speed of

50 mph (80 km/h).

Note: The temporary mobility kit sealant compound in the canister is to

be used for one tire only. See your Ford authorized dealer for additional

replacement sealant canisters.

2009 Focus (foc)

Owners Guide, 1st Printing

USA (fus)

Roadside Emergencies

198

1 2 ... 193 194 195 196 197 198 199 200 201 202 203 ... 275 276

Pas de commentaire

Ford 2009 Focus v.1 Manuel d'utilisateur Page 198