Ford 2009 Focus v.1 Manuel d'utilisateur télécharger pdf (Page 126)

5. To put the retractor in the

automatic locking mode, grasp the

shoulder portion of the belt and pull

downward until all of the belt is

pulled out.

Note: The automatic locking mode

is available on the front passenger

and rear outboard seats only. The

rear center seating position has a

cinch tongue. Refer to Installing

child safety seats in cinch tongue

combination lap shoulder belt seating positions (rear center position

only) in this chapter.

6. Allow the belt to retract to remove slack. The belt will click as it

retracts to indicate it is in the automatic locking mode.

7. Try to pull the belt out of the retractor to make sure the retractor is

in the automatic locking mode (you should not be able to pull more belt

out). If the retractor is not locked, unbuckle the belt and repeat Steps 5

and 6.

8. Remove remaining slack from the

belt. Force the seat down with extra

weight, e.g., by pressing down or

kneeling on the child restraint while

pulling up on the shoulder belt in

order to force slack from the belt.

This is necessary to remove the

remaining slack that will exist once

the additional weight of the child is

added to the child restraint. It also

helps to achieve the proper

snugness of the child seat to the vehicle. Sometimes, a slight lean

towards the buckle will additionally help to remove remaining slack from

the belt.

9. Attach the tether strap (if the child seat is equipped). Refer to

Attaching child safety seats with tether straps later in this chapter.

2009 Focus (foc)

Owners Guide, 1st Printing

USA (fus)

Seating and Safety Restraints

126

1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 275 276

Pas de commentaire

Ford 2009 Focus v.1 Manuel d'utilisateur Page 126