Ford 2009 Expedition v.2 Manuel d'utilisateur télécharger pdf (Page 384)

Note: A fuel spillage concern may occur if overfilling the fuel tank. Do

not overfill the tank to the point that the fuel is able to bypass the fuel

filler nozzle. The overfilled fuel may run down the drain located below

and in front of the fuel filler door.

If the Check Fuel Fill Inlet lamp or Check Fuel Fill Inlet message comes

on, the fuel fill inlet may not have properly closed. The inlet may have

stuck open or debris may be preventing the inlet from fully closing. At

the next opportunity, safely pull off the road, turn off the engine, open

the fuel filler door and remove any visible debris from the fuel fill

opening. Insert either the fuel fill nozzle or the fuel fill funnel (see

Refilling with a portable fuel container for funnel location) provided

with the vehicle several times to dislodge any debris and/or allow the

inlet to close properly. If this action corrects the problem, the Check

Fuel Fill Inlet lamp or Check Fuel Fill Inlet message may not reset

immediately. It may take several driving cycles for the Check Fuel Fill

Inlet lamp or Check Fuel Fill Inlet message to turn off. A driving cycle

consists of an engine start-up (after four or more hours with the engine

off) followed by city/highway driving. Continuing to drive with the Check

Fuel Fill Inlet lamp or Check Fuel Fill Inlet message on may cause the

Service Engine Soon lamp to turn on as well.

WARNING: The fuel system may be under pressure. If you hear

a hissing sound near the fuel filler door (Easy Fuel™ “no cap”

fuel system), do not refuel until the sound stops. Otherwise, fuel may

spray out, which could cause serious personal injury.

Flex Fuel Vehicle (FFV) fuel fill inlet

Flex fuel vehicles have a yellow bezel placed over the fuel fill inlet.

2009 Expedition (exd)

Owners Guide, 2nd Printing

USA (fus)

Maintenance and Specifications

384

1 2 ... 379 380 381 382 383 384 385 386 387 388 389 ... 414 415

Pas de commentaire

Ford 2009 Expedition v.2 Manuel d'utilisateur Page 384