Ford 2008 Ranger v.2 Manuel d'utilisateur télécharger pdf (Page 45)

Note: If the battery is disconnected, discharged, or a new battery is

installed, the dimmer switch requires re-calibration. Rotate the dimmer

switch from the full dim position to the full Dome/ON position to reset.

This will ensure that your displays are visible under all lighting

conditions.

AIMING THE HEADLAMPS

The headlamps on your vehicle are properly aimed before leaving the

assembly plant. If your vehicle is involved in an accident or if you have

problems fixing the alignment of your headlamps, have them checked by

a qualified service technician.

Headlamp aim adjustment

The headlamps are designed to be mechanically aimed, but can also be

aimed visually by doing the following:

1. Park your vehicle on a level surface about 25 feet (7.6 meters) away

from a vertical plain surface (3). Check your headlamp alignment at

night or in a dark area so that you can see the headlamp beam pattern.

• (1) 8 feet (2.4 meters)

• (2) Center height of lamp to

ground

• (3) 25 feet (7.6 meters)

• (4) Horizontal reference line

• (5) Center of headlamps

• (6) Center line of the vehicle

2. The center of the headlamp is

marked either on the lens (a circle

or cross marker) or on the bulb shield, internal to the lamp (mark or

feature). Measure the height from the center of your headlamp to the

ground (2) and mark an 8 foot (2.4 meter) long horizontal line on the

wall or screen (1) at this height (masking tape works well).

2008 Ranger (ran)

Owners Guide (post-2002-fmt)

USA (fus)

Lights

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 271 272

Pas de commentaire

Ford 2008 Ranger v.2 Manuel d'utilisateur Page 45