Ford 2008 Edge Manuel d'utilisateur télécharger pdf (Page 162)

• Grasp the shoulder portion and

pull downward until the entire

belt is pulled out.

• Allow the belt to retract. As the belt retracts, you will hear a clicking

sound. This indicates the safety belt is now in the automatic locking

mode.

When to use the automatic locking mode

In this mode, the shoulder belt is automatically pre-locked. The belt will

still retract to remove any slack in the shoulder belt. The automatic

locking mode is not available on the driver safety belt.

This mode should be used any time a child safety seat, except a

booster, is installed in passenger front or rear seating positions. Children

12 years old and under should be properly restrained in the rear seat

whenever possible. Refer to Safety restraints for children or Safety

seats for children later in this chapter.

How to disengage the automatic locking mode

Ford Motor Company recommends that all passenger safety belt

assemblies and attaching hardware should be inspected by an

authorized dealer after any collision to verify that the ⬙automatic

locking retractor⬙ feature for child seats is still working properly. Safety

belt assemblies should be inspected by an authorized dealer and must

be replaced if either damage or improper operation is noted. Failure to

replace the belt and retractor assembly could increase the risk of

injury in a collision.

Unbuckle the combination lap/shoulder belt and allow it to retract

completely to disengage the automatic locking mode and activate the

vehicle sensitive (emergency) locking mode.

Safety belt pretensioner

Your vehicle is equipped with safety belt pretensioners at the driver and

front outboard passenger seating positions.

2008 Edge (edg)

Owners Guide (post-2002-fmt)

USA (fus)

Seating and Safety Restraints

162

1 2 ... 157 158 159 160 161 162 163 164 165 166 167 ... 335 336

Pas de commentaire

Ford 2008 Edge Manuel d'utilisateur Page 162