Ford 2008 E-450 v.3 Manuel d'utilisateur télécharger pdf (Page 109)

2. Route the child safety tether

strap over the back of the bench

seat.

3. Clip the center tether strap hook

to the tether bracket mounted

under rear rail of seat cushion

frame. Clip the outboard tether

strap hooks to the tether bracket

slot provided on the left side of each

seat pedestal. The slot is located

between the two holes.

4. Install the child safety seat tightly using the LATCH anchors or safety

belts. Follow the instructions in this chapter.

5. Tighten the child safety seat tether strap according to the

manufacturer’s instructions.

For additional important safety information on the proper use of safety

belts, child seats and infant seats, please read the entire Seating and

Safety Restraints chapter in this Owner’s Guide.

Attaching child safety seats with LATCH

(Lower Anchors and Tethers for Children) attachments for child

seat anchors

Some child safety seats have two rigid or webbing mounted attachments

that connect to two anchors at certain seating positions in your vehicle.

This type of child seat eliminates the need to use safety belts to attach

the child seat. For forward-facing child seats, the tether strap must also

be attached to the proper tether anchor. See Attaching child safety

seats with tether straps in this chapter.

Your vehicle may be equipped with LATCH anchors for child seat

installation at the seating positions marked with the child seat symbol:

2008 Econoline (eco)

Owners Guide (post-2002-fmt)

USA (fus)

Seating and Safety Restraints

109

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 284 285

Pas de commentaire

Ford 2008 E-450 v.3 Manuel d'utilisateur Page 109