Ford 2007 Fusion v.2 Manuel d'utilisateur télécharger pdf (Page 57)

Handle a halogen headlamp bulb carefully and keep out of

children’s reach. Grasp the bulb only by its plastic base and do

not touch the glass. The oil from your hand could cause the bulb to

break the next time the headlamps are operated.

12. After the new bulb is installed, carefully let the bulb socket dangle

downward near the lamp housing (Passenger side only with ABS).

13. From the exterior wheel well area reach arm through splash shield

opening to install bulb socket with new bulb (Passenger side only with

ABS).

14. Install the new bulb socket into the lamp assembly by aligning the

indexing fingers, then rotate clockwise to locked position.

15. Install the protective cap/grill to the housing circular ring by pushing

and pressing it forward.

16. Re-apply pressure around the complete circular ring on the housing

to make sure the protective cap is completely seated.

17. Reinstall splash shield access panel with screw (Passenger side only

with ABS).

18. Reinstall the AirTube to the air filter assembly. (Driver’s side only).

19. Reinstall the vertical shield to the bolster. (Driver’s side only).

20. Turn the headlamps on and make sure they work properly. If the

headlamp was correctly aligned before you changed the bulb, you should

not need to align it again.

Replacing front parking lamp/turn signal bulbs

1. Make sure headlamp switch is in the OFF position, then open the

hood.

2. Reach over the front bolster.

2007 Fusion (fsn)

Owners Guide (post-2002-fmt)

USA (fus)

Lights

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 279 280

Pas de commentaire

Ford 2007 Fusion v.2 Manuel d'utilisateur Page 57