Ford 2007 Fusion v.2 Manuel d'utilisateur télécharger pdf (Page 241)

• 2.3L coolant bleed valve

• 3.0L coolant bleed valve

5. Open the coolant bleed valve on the back of the engine water outlet

for the 2.3L engine or the coolant bleed valve located on the upper

radiator hose for the 3.0L engine.

6. Fill the coolant reservoir slowly with the proper coolant mixture (see

above), to within the “COLD FILL RANGE” or the “FULL COLD” level on

the reservoir.

7. Close the bleed valve and reinstall the cap on the coolant reservoir.

Turn the cap until it is tightly installed to prevent coolant loss.

After any coolant has been added, check the coolant concentration.

Refer to the Checking engine coolant section. If the concentration is

not 50/50 (protection to –34° F [–36° C]), drain some coolant and adjust

the concentration. It may take several drains and additions to obtain a

50/50 coolant concentration.

Whenever coolant has been added, the coolant level in the coolant

reservoir should be checked the next few times you drive the vehicle. If

necessary, add enough 50/50 concentration of engine coolant and

distilled water to bring the liquid level to the proper level.

If you have to add more than 1.0 quart (1.0 liter) of engine coolant per

month, have your authorized dealer check the engine cooling system.

2007 Fusion (fsn)

Owners Guide (post-2002-fmt)

USA (fus)

Maintenance and Specifications

241

1 2 ... 236 237 238 239 240 241 242 243 244 245 246 ... 279 280

Pas de commentaire

Ford 2007 Fusion v.2 Manuel d'utilisateur Page 241