Ford 2007 Edge v.2 Manuel d'utilisateur télécharger pdf (Page 147)

Use only extensions manufactured by the same supplier as the safety

belt. Manufacturer identification is located at the end of the webbing on

the label. Also, use the safety belt extension only if the safety belt is too

short for you when fully extended.

Do not use extensions to change the fit of the shoulder belt

across the torso.

Safety belt maintenance

Inspect the safety belt systems periodically to make sure they work

properly and are not damaged. Inspect the safety belts to make sure

there are no nicks, tears or cuts. Replace if necessary. All safety belt

assemblies, including retractors, buckles, front safety belt buckle

assemblies, buckle support assemblies (slide bar-if equipped), shoulder

belt height adjusters (if equipped), shoulder belt guide on seatback (if

equipped), child safety seat LATCH and tether anchors, and attaching

hardware, should be inspected after a collision. Ford Motor Company

recommends that all safety belt assemblies in use in vehicles involved in

a collision be replaced. However, if the collision was minor and an

authorized dealer finds that the belts do not show damage and continue

to operate properly, they do not need to be replaced. Safety belt

assemblies not in use during a collision should also be inspected and

replaced if either damage or improper operation is noted.

Failure to inspect and if necessary replace the safety belt

assembly under the above conditions could result in severe

personal injuries in the event of a collision.

For proper care of soiled safety belts, refer to Interior in the Cleaning

chapter.

Safety belt warning light and indicator chime

The safety belt warning light illuminates in the instrument cluster and a

chime sounds to remind the occupants to fasten their safety belts.

2007 Edge (edg)

Owners Guide (post-2002-fmt)

USA (fus)

Seating and Safety Restraints

147

1 2 ... 142 143 144 145 146 147 148 149 150 151 152 ... 319 320

Pas de commentaire

Ford 2007 Edge v.2 Manuel d'utilisateur Page 147