Ford 2007 Edge v.2 Manuel d'utilisateur télécharger pdf (Page 115)

Power door lock switch autounlock enable/disable procedure

Before starting, ensure the ignition is in the 1 (LOCK) position and all

vehicle doors are closed. You must complete Steps 1–5 within 30 seconds

or the procedure will have to be repeated. If the procedure needs to be

repeated, wait a minimum of 30 seconds before beginning again.

1. Place the key in the ignition and

turn the ignition to the 3 (RUN)

position.

2. Press the power door unlock

control on the door panel three

times.

3. Turn the ignition from the

3 (RUN) position to the 1 (LOCK)

position.

4. Press the power door unlock

control on the door panel three times.

5. Turn the ignition back to the 3 (RUN) position. The horn will chirp

one time to confirm programming mode has been entered and is active.

6. To enable/disable the autounlock feature, press the lock control, then

press the unlock control. The horn will chirp once if autounlock was

deactivated or twice (one short and one long chirp) if autounlock was

activated.

7. Turn the ignition to the 1 (LOCK) position. The horn will chirp once

to confirm the procedure is complete.

Keyless entry key pad autounlock enable/disable procedure

1. Turn the ignition to the 1 (LOCK)

position.

2. Close all the doors.

3. Enter factory–set 5–digit entry

code.

4. Press and hold the 3 • 4. While holding the 3 • 4, press and release

the 7 • 8. While still holding the 3 • 4, press and release the 7 • 8a

second time.

5. Release the 3 • 4.

The user should receive a horn chirp to indicate the system has been

disabled or a chirp followed by a honk to indicate the system has been

enabled.

2007 Edge (edg)

Owners Guide (post-2002-fmt)

USA (fus)

Locks and Security

115

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 319 320

Pas de commentaire

Ford 2007 Edge v.2 Manuel d'utilisateur Page 115