Ford 2006 Fusion v.1 Manuel d'utilisateur télécharger pdf (Page 46)

Replacing front side marker bulbs

1. Make sure the headlamp control

is in the OFF position.

2. Pry the lamp away from the

vehicle at the rear of lamp at the

wheel opening. (Rotate lamp from

the wheel opening away from the

vehicle), as the lamp separates from

the vehicle, slide the lamp towards

the wheel opening to disengage

lamp

3. Rotate the lamp clockwise while

holding the electrical connector in

place with your other hand. After

rotating the lamp 90 degrees

clockwise, pull and disengage the

wire harness and bulb from the

lamp.

4. With the bulb exposed, carefully remove the bulb from the socket by

grasping the bulb and pulling it away from the wire harness.

Replace with a new bulb, and reverse the removal steps to complete the

process.

Replacing tail/brake/turn signal/backup lamp bulbs

The tail/brake/turn signal and backup lamp bulbs are located in the tail

lamp assembly. Follow the same steps to replace either bulb.

1. Make sure the headlamp switch is in the OFF position and open the

trunk.

2. A hard carpet shingles over a soft carpet at lamp area. Carefully

pull/push the soft carpet outboard to expose the lamp assembly.

2006 Fusion (fsn)

Owners Guide (post-2002-fmt)

USA (fus)

Lights

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 263 264

Pas de commentaire

Ford 2006 Fusion v.1 Manuel d'utilisateur Page 46