Ford 2005 GT Manuel d'utilisateur télécharger pdf (Page 29)

To deactivate/reactivate the autolock feature using the power door

unlock control

You must complete steps 1-7 within 30 seconds or the procedure will

have to be repeated. If the procedure needs to be repeated, you must

wait 30 seconds. Note: The default setting for the autolock feature is

“disabled.”

1. Turn the ignition to the 3 (ON) position. Note: Both vehicle doors

must be closed during the activation/deactivation procedure.

2. Press the power door unlock control three times.

3. Turn the ignition from 3 (ON) position to the 1 (OFF/LOCK) position.

4. Press the power door unlock control three times.

5. Turn the ignition back to 3 (ON) position. The horn will chirp.

6. Press the unlock control, then press the lock control. The horn will

chirp once if autolock was deactivated or twice (one short and one long

chirp) if autolock was activated.

7. Turn the ignition to the 1 (OFF/LOCK) position. The horn will chirp

once to confirm the procedure is complete.

REMOTE ENTRY SYSTEM

This device complies with part 15 of the FCC rules and with RS-210 of

Industry Canada. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) This device

must accept any interference received, including interference that may

cause undesired operation.

Changes or modifications not expressly approved by the party

responsible for compliance could void the user’s authority to

operate the equipment.

The typical operating range for your remote entry transmitter is

approximately 33 feet (10 meters). A decrease in operating range could

be caused by:

• weather conditions,

• nearby radio towers,

• structures around the vehicle, or

• other vehicles parked next to your vehicle.

2005 GT (gto)

Owners Guide (post-2002-fmt)

USA_English (fus)

Locks and Security

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 199 200

Pas de commentaire

Ford 2005 GT Manuel d'utilisateur Page 29