Ford 2005 F-150 Manuel d'utilisateur télécharger pdf (Page 90)

2. Do not wipe off any grease on the

battery terminals on the back

surface of the circuit board.

3. Remove the old battery. Note: Please refer to local regulations when

disposing of transmitter batteries.

4. Insert the new battery. Refer to the diagram inside the remote entry

transmitter for the correct orientation of the battery. Press the battery

down to ensure that the battery is fully seated in the battery housing

cavity.

5. Snap the two halves back together.

Note: Replacement of the battery will not cause the remote transmitter

to become deprogrammed from your vehicle. The remote transmitter

should operate normally after battery replacement.

Replacing lost transmitters

If a remote transmitter has been lost and you would like to remove it

from the vehicle’s memory, or you would like to purchase additional

remote transmitters and have them programmed to your vehicle:

• Take all your vehicle’s transmitters to your authorized dealer for

programming, or

• Perform the programming procedure yourself.

Programming remote transmitters

It is necessary to have all (maximum of six — original and/or new) of

your remote transmitters available prior to beginning this procedure. If

all remote entry transmitters are not present during the programming

procedure, the transmitters that are not present during programming will

no longer operate the vehicle.

2005 F-150 (f12)

Owners Guide (post-2002-fmt)

USA (fus)

Locks and Security

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 311 312

Pas de commentaire

Ford 2005 F-150 Manuel d'utilisateur Page 90