Ford 2005 Crown Victoria Manuel d'utilisateur télécharger pdf (Page 81)

3. Cycle the ignition from the 3 (ON) to the 1 (OFF/LOCK) position.

4. Press the power door unlock control three times.

5. Turn the ignition to the 3 (ON) position. The doors will lock and

unlock.

6. With the ignition still in the 3 (ON) position, press the unlock control

twice.

7. After a five to ten second delay, the door locks will cycle lock/unlock

to confirm successful programming.

8. After having waited the necessary time for the programming to

confirm, turn the ignition to the 1 (OFF/LOCK) position.

Sounding a panic alarm

Press

on the remote transmitter to activate the alarm. Note: The

panic alarm only works with the ignition in the 1 (OFF/LOCK) position.

Press

a second time to deactivate the alarm. You may also

deactivate the alarm by turning the ignition to the 2 (ACCESSORY) or 3

(ON) position.

Opening the trunk

Press once to open the trunk.

• Ensure that the trunk is closed and latched before driving your

vehicle. Failure to properly latch the trunk may cause objects to fall

out or block the driver’s rear view.

This feature will not work with the transmission out of P (Park) or N

(Neutral) if the ignition is in either the 2 (ACC) or 3 (ON) position.

Replacing the battery

The remote entry transmitter uses one coin type three-volt lithium

battery CR2032 or equivalent.

2005 Crown Victoria (cro)

Owners Guide (post-2002-fmt)

USA_English (fus)

Locks and Security

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 255 256

Pas de commentaire

Ford 2005 Crown Victoria Manuel d'utilisateur Page 81