Ford 2004 Escape v.2 Manuel d'utilisateur télécharger pdf (Page 68)

Locking the doors

1. Press and release to lock all the doors. The park lamps will flash

once and the perimeter alarm (if equipped) will start the arming process.

For more information concerning the perimeter alarm, refer to

Perimeter alarm system (if equipped) later in this chapter.

2. Press

and release again within three seconds to confirm that all the

doors are closed and locked. Note: The doors will lock again and the

horn will chirp once.

If any of the doors or the hood are not properly closed the horn will not

sound and the park lamps will not flash.

Sounding a panic alarm

Press

to activate the alarm. To deactivate the feature, press the

control again or wait for the alarm to time out in approximately 3

minutes.

Note: The panic alarm will only operate when the ignition is in the 1

(LOCK) or 2 (ACC) position.

Replacing the battery

The remote entry transmitter uses one coin type three-volt lithium

battery CR2032 or equivalent.

To replace the battery:

1. Twist a thin coin between the two

halves of the remote entry

transmitter near the key ring. DO

NOT TAKE THE RUBBER COVER

AND CIRCUIT BOARD OFF THE

FRONT HOUSING OF THE

REMOTE ENTRY TRANSMITTER.

2004 Escape (204)

Owners Guide (post-2002-fmt)

USA English (fus)

Locks and Security

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 255 256

Pas de commentaire

Ford 2004 Escape v.2 Manuel d'utilisateur Page 68