Ford 2004 Escape v.1 Manuel d'utilisateur télécharger pdf (Page 41)

6. Without turning, carefully pull

bulb out of headlamp assembly.

Handle a halogen headlamp

bulb carefully and keep out

of children’s reach. Grasp the bulb

only by its metal base and do not

touch the glass. The oil from your

hand could cause the bulb to

break the next time the

headlamps are operated.

Note: The bulb’s metal base gets very hot during headlamp operation.

Be sure the bulb base is cool before handling.

If the bulb is accidentally touched, it should be cleaned with rubbing

alcohol before being used.

7. Insert the glass end of the new bulb into the headlamp assembly.

When the bulb’s three metal tabs are aligned with the grooves in the

plastic base, push the bulb into the lamp assembly until the bulb’s metal

base contacts the plastic base.

8. Rotate the retainer spring over the bulb metal base and secure it on

the bulb hooks.

9. Install rubber boot on the lamp assembly. Be sure to press firmly

around the perimeter of the boot and around the bulb to ensure the

proper seal of the bulb.

10. Connect the electrical connector into the rear of the bulb until it

“snaps.”

Replacing brake/tail/turn/backup lamp bulbs

The brake/tail/turn/backup lamp bulbs are located in the tail lamp

assembly, one just below the other. Follow the same steps to replace

either bulb:

2004 Escape (204)

Owners Guide (post-2002-fmt)

USA English (fus)

Lights

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 239 240

Pas de commentaire

Ford 2004 Escape v.1 Manuel d'utilisateur Page 41