Ford 2003 Crown Victoria v.3 Manuel d'utilisateur télécharger pdf (Page 59)

4. Install the protective cover over headlamps locking it in place with

three knobs.

5. Turn the headlamps on and make sure they work properly. If the

headlamp was correctly aligned before you changed the bulb, you should

not need to align it again.

Replacing front parking lamp/turn signal bulbs

The park/turn lamp bulbs can be replaced with out removing the

headlamp assembly.

1. Make sure headlamp switch is in OFF position, then open the hood.

2. Remove the radiator cover by turning the three knobs to the unlock

position.

3. Loosen the parking lamp retainer, on the outside of the lamp, screw

and pull the lamp assembly forward.

4. Disconnect the electrical

connector from the bulb by pulling

rearward.

5. Rotate the bulb socket

counterclockwise and remove from

lamp assembly.

6. Carefully pull bulb straight out of

the socket and push in the new bulb

until it snaps, locking it into

position.

7. To complete installation, follow the removal procedure in reverse

order.

Replacing tail lamp/brake/turn lamp bulbs

The tail lamp, the brake lamp and the turn signal lamp bulbs are located

in the tail lamp assembly. Follow the same steps to replace either bulb.

Lights

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 247 248

Pas de commentaire

Ford 2003 Crown Victoria v.3 Manuel d'utilisateur Page 59