Ford 2002 Windstar v.2 Manuel d'utilisateur télécharger pdf (Page 137)

To install the seat:

1. Remove (if necessary) tub covers from the floor to expose the seat

mounts.

• To remove the tub cover(s), use a

screwdriver to pry the tub cover

(where indicated) upward and

out of the floor tub.

• To install the tub cover(s), first

insert the tabs located on the

opposite side of the pry location

into the slots of the floor tub then

press down on the other side of

the cover until it snaps into place

securely. (Additional tub covers

can be purchased as an accessory

from your dealer.)

2. Position the seat in the vehicle.

The 3rd row bench seat can be

placed in the 2nd row position.

3. Align seat front hooks to front tub pins, lower back of seat into the

rear tubs until both release controls latch into place. Be sure that the

seat is locked in place both front and back.

4. Make sure the safety belt is not twisted, then insert the seat belt

tongue into detachable anchor (if equipped) until you hear a “click” and

feel the latch engage.

Seating and Safety Restraints

137

1 2 ... 132 133 134 135 136 137 138 139 140 141 142 ... 287 288

Pas de commentaire

Ford 2002 Windstar v.2 Manuel d'utilisateur Page 137