Ford 2002 F-150 v.1 Manuel d'utilisateur télécharger pdf (Page 95)

After completing the “Programming” functions, follow these steps to

train a garage door opener with the rolling code feature:

1. Locate the training button on the garage door motor head unit.

Refer to the garage door opener manual or call 1–800–355–3515 or on

the Internet at HomeLink.jci.com if there is difficulty locating the

training button.

2. Press the training button on the garage door motor head unit (which

will activate the “training” light).

3. Press and release the

programmed HomeLinkt button.

Press and release the HomeLinkt

button a second time to complete

the training process. (Some garage

door openers may require this

procedure to be done a third time

to complete the training.)

The 2nd or 3rd press from step 3 will activate the door. The HomeLinkt

Universal Transceiver has now been trained to the receiver. The

remaining two buttons may now be programmed if this has not

previously been done.

Erasing HomeLinkT buttons

Individual buttons cannot be erased,

however, to erase the three

programmed buttons:

1. Hold down the two outside

buttons until the red light begins to

flash after 20 seconds.

2. Release both buttons.

Reprogramming a single HomeLink

button

To program a device to HomeLinkt using a HomeLinkt button previously

trained, follow these steps:

1. Press and hold the desired HomeLinkt button. Do NOT release until

step 4 has been completed.

2. When the indicator light begins to flash slowly (after 20 seconds),

position the hand-held transmitter 5–14 cm (2 to 5 inches) away from

the HomeLinkt surface.

3. Press and hold the hand-held transmitter button.

REC DEL PLAY

Driver Controls

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 319 320

Pas de commentaire

Ford 2002 F-150 v.1 Manuel d'utilisateur Page 95