Ford 2002 Explorer v.1 Manuel d'utilisateur télécharger pdf (Page 19)

Compass calibration adjustment

Perform this adjustment in an open area free from steel structures and

high voltage lines:

For optimum calibration, turn off all electrical accessories (heater/air

conditioning, wipers, etc.) and make sure all vehicle doors are shut.

1. Start the vehicle.

2. Locate compass sensor mounted at base of mirror.

3. Insert a paperclip into the small

hole on the bottom of the compass

sensor. Hold down until ZONE

appears in the instrument cluster

display. Continue to hold down until

ZONE disappears and CAL is displayed.

4. Press and hold the control until CAL appears in the display

(approximately eight seconds) and release.

5. Drive the vehicle slowly (less than 5 km/h [3 mph]) in circles until

CAL indicator turns off (4-5 complete circles).

6. The compass is now calibrated.

MESSAGE CENTER (IF EQUIPPED)

With the ignition in the ON position,

the message center, located on your

instrument cluster, displays

important vehicle information

through a constant monitor of

vehicle systems. You may select

display features on the message center for a display of status preceded

by a brief indicator chime. The system will also notify you of potential

vehicle problems with a display of system warnings followed by a long

indicator chime.

Selectable features

Reset

Press this control to select and reset functions shown in the INFO menu

and SETUP menu.

Instrumentation

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 311 312

Pas de commentaire

Ford 2002 Explorer v.1 Manuel d'utilisateur Page 19