Ford 2002 Explorer v.1 Manuel d'utilisateur télécharger pdf (Page 106)

• Press and hold the trained HomeLinkt button. The device has the

rolling code feature if the indicator light flashes rapidly and then turns

solid after two seconds.

After completing the “Programming” functions, follow these steps to

train a garage door opener with the rolling code feature:

1. Locate the training button on the garage door motor head unit.

Refer to the garage door opener manual or call 1–800–355–3515 or on

the Internet at HomeLink.jci.com. if there is difficulty locating the

training button.

2. Press the training button on the garage door motor head unit (which

will activate the “training” light” ).

3. Press and release the

programmed HomeLinkt button.

Press and release the HomeLinkt

button a second time to complete

the training process. (Some garage

door openers may require this

procedure to be done a third time

to complete the training).

The 2nd or 3rd press from step 3

will activate the door. The

HomeLinkt Universal Transceiver

has now been trained to the receiver. The remaining two buttons may

now be programmed if this has not previously been done.

Erasing HomeLinkT buttons

Individual buttons cannot be erased,

however, to erase the three

programmed buttons:

1. Hold down the two outside

buttons until the red light begins to

flash after 20 seconds.

2. Release both buttons.

Controls and features

106

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 311 312

Pas de commentaire

Ford 2002 Explorer v.1 Manuel d'utilisateur Page 106