Ford 2002 Excursion v.3 Manuel d'utilisateur télécharger pdf (Page 127)

20815.psp Ford O/G 2002 Excursion English 4th Print 2C3J-19A321-HB 04/24/2003 09:14:57 64 A

1. Pull the seat release lever located

on the lower right side of the

seatback while pushing the seatback

down onto the seat cushion.

• The seatback will latch onto the

cushion.

2. Lift the seat release bar located

at the center of the seat near the

floor to release the floor latches.

3. While pulling up on the release

bar, lift the seat up and out of the floor tubs and roll seat rearward.

4. With assistance, lift the seat out of the vehicle.

Installing the third row seat

Always latch the vehicle seat to the floor, whether the seat is

occupied or empty. If not latched, the seat may cause injury

during a sudden stop.

When reinstalling a rear seat in your vehicle it must be placed in

its original position. Improper installation of the seat will prevent

correct use of the safety belts and could increase the risk of injury.

Refer to the warning label on the seat belt.

For proper latching, ensure that the

floor tubs are clear of debris.

From the rear of the vehicle, with

the liftgate open:

1. With assistance, lift the seat into

the rear of the vehicle. Roll the seat

forward and guide the front locators

over the seat locator pins of the

front floor tubs.

• When the rear of the seat is 10–13 cm (4–5 in) above the rear pins,

let the seat drop. This will ensure that the seat will properly latch into

the floor.

2. Push up on the seat to verify that it is latched into the floor.

3. Verify that the safety belts can move freely on either side of the seat.

Seating and Safety Restraints

127