Ford 2000 F-550 v.1 Manuel d'utilisateur télécharger pdf (Page 157)

4. Insert the hooked end of the jack

handle into the rear bumper drive

tube.

The handle will stop moving and

you will feel forward resistance to

turning when properly engaged.

5. Turn the handle counterclockwise

and lower the spare until you can

slide the tire rearward and the cable

is slack.

6. Remove the retainer through the center of the wheel.

Stowing the spare tire

1. Lay the tire on the ground with the valve stem facing up.

2. Slide the wheel under the vehicle

and install the retainer through the

wheel center.

3. Turn the jack handle clockwise

until the tire is raised to its original

position underneath the vehicle. The

effort to turn the jack handle

increases significantly and the spare

tire carrier ratchets when the tire is

raised to the stowed position. The spare tire carrier has a built-in ratchet

feature that will not allow you to overtighten.

4. Check that the tire lies flat to the frame assembly. Push against the

tire to make sure it is tightly seated under the vehicle. Loosen or

retighten if necessary.

5. If removed, install the spare tire lock into the bumper drive tube with

the spare tire lock key and jack handle.

6. The following steps are required to secure the support bracket (if

equipped) under the spare tire:

• Move the support bracket over the spare tire.

• Slide the support bracket over the eyebolt into the slot on the support

bracket.

• Tighten the eyebolt with tapered end of lug wrench leaving it

positioned at a right angle of the slot on the support bracket.

Roadside emergencies

157

1 2 ... 152 153 154 155 156 157 158 159 160 161 162 ... 255 256

Pas de commentaire

Ford 2000 F-550 v.1 Manuel d'utilisateur Page 157