Ford 1999 Windstar Manuel d'utilisateur télécharger pdf (Page 82)

Programming

1. Prepare for programming the

HomeLinkt Universal Transceiver by

erasing the three factory default

codes by holding down the two

outside buttons until the red light

begins to flash after 20 seconds.

Release both buttons.

2. Hold the end of your hand-held

transmitter 5–14 cm (2–5 inches)

away from the HomeLinkt Universal

Transceiver surface (located on your visor) while keeping the red light in

view.

3. Using both hands simultaneously

press and hold the hand-held

transmitter button and the desired

HomeLinkt button. Do not release

the buttons until step 4 has been

completed.

4. The red light will flash slowly and

then rapidly. Release both buttons

when the red light flashes rapidly.

5. Follow steps 2 through 4 to program the remaining two buttons.

If you do not successfully program the HomeLinkt Universal Transceiver

after repeated attempts, refer to Rolling code programing which

follows, or call toll-free customer assistance: 1–800–355–3515 or on the

Internet at HomeLink.jci.com.

Canadian Programming

During programming, your hand-held transmitter may automatically stop

transmitting after two seconds which may not be long enough to

program the HomeLinkt Universal Transceiver.

Controls and features

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 247 248

Pas de commentaire

Ford 1999 Windstar Manuel d'utilisateur Page 82