Ford 2015 Focus Manuel d'utilisateur télécharger pdf (Page 248)

WARNING

Under-inflation is the most

common cause of tire failures

and may result in severe tire

cracking, tread separation or

blowout, with unexpected loss of

vehicle control and increased risk

of injury. Under-inflation increases

sidewall flexing and rolling

resistance, resulting in heat

buildup and internal damage to

the tire. It also may result in

unnecessary tire stress, irregular

wear, loss of vehicle control and

accidents. A tire can lose up to

half of its air pressure and not

appear to be flat!

You are strongly urged to buy a

reliable tire pressure gauge, as

automatic service station gauges

may be inaccurate. Ford

recommends the use of a digital

or dial-type tire pressure gauge

rather than a stick-type tire

pressure gauge.

Use the recommended cold

inflation pressure for optimum tire

performance and wear.

Under-inflation or over-inflation

may cause uneven treadwear

patterns.

Always inflate your tires to the

Ford recommended inflation

pressure even if it is less than the

maximum inflation pressure

information found on the tire. The

Ford recommended tire inflation

pressure is found on the Safety

Compliance Certification Label

(affixed to either the door hinge

pillar, door-latch post, or the door

edge that meets the door-latch

post, next to the driver's seating

position), or Tire Label which is

located on the B-Pillar or the edge

of the driver door. Failure to follow

the tire pressure

recommendations can cause

uneven treadwear patterns and

adversely affect the way your

vehicle handles.

Maximum Inflation Pressure is

the tire manufacturer's maximum

permissible pressure or the

pressure at which the maximum

load can be carried by the tire. This

pressure is normally higher than

the manufacturer’ s recommended

cold inflation pressure, which can

be found on the Safety

Compliance Certification Label

(affixed to either the door hinge

pillar, door-latch post, or the door

edge that meets the door-latch

post, next to the driver's seating

position), or Tire Label which is

located on the B-Pillar or the edge

of the driver’s door. The cold

inflation pressure should never be

set lower than the recommended

pressure on the Safety

Compliance Certification Label or

Tire Label.

245

Focus (CDH), enUSA, First Printing

Wheels and Tires

1 2 ... 243 244 245 246 247 248 249 250 251 252 253 ... 452 453

Commentaires sur ces manuels

Pas de commentaire