Ford 2013 Fusion Hybrid v.2 Manuel d'utilisateur télécharger pdf (Page 136)

Ignition Modes

E144447

The keyless starting system has three

modes:

• Off: Turns the ignition off.

• Without applying the brake pedal,

press and release the button once

when the ignition is in the on mode,

or when the engine is running but

the vehicle is not moving.

• On: All electrical circuits are

operational and the warning lamps and

indicators illuminate.

• Without applying the brake pedal,

press and release the button once.

• Start: Starts the engine.

• Press the brake pedal, and then

press the button for any length of

time. An indicator light on the

button illuminates when then

ignition is on and when the engine

starts.

STARTING A GASOLINE

ENGINE

When the engine starts for the first time

on your drive, the idle speed increases, this

helps to warm up the engine. If the engine

idle speed does not slow down

automatically, have your vehicle checked

by an authorized dealer.

Note: You can crank the engine for a total

of 60 seconds (without the engine starting)

before the starting system temporarily

disables. The 60 seconds does not have to

be all at once. For example, if you crank the

engine three times for 20 seconds each

time, without the engine starting, you

reached the 60-second time limit. A

message appears in the information display

alerting you that you exceeded the cranking

time. You cannot attempt to start the engine

for at least 15 minutes. After 15 minutes, you

are limited to a 15-second engine cranking

time. You need to wait 60 minutes before

you can crank the engine for 60 seconds

again.

Before starting the vehicle, check the

following:

• Make sure all occupants have fastened

their safety belts.

• Make sure the headlamps and

electrical accessories are off.

• Make sure the parking brake is on.

• Move the transmission selector lever

to position P.

• Turn the ignition key to position II. If

your vehicle is equipped with a keyless

ignition, see the following instructions.

Vehicles with an Ignition Key

Note: Do not touch the accelerator pedal.

1. Fully press the brake pedal.

2. Turn the key to position III to start the

vehicle. Release the key when the

vehicle starts.

Note: The engine may continue cranking

for up to 15 seconds or until it starts.

Note: If you cannot start the engine on the

first try, wait for a short period and try again.

Vehicles with Keyless Start

Note: Do not touch the accelerator pedal.

1. Fully press the brake pedal.

133

Starting and Stopping the Engine

1 2 ... 131 132 133 134 135 136 137 138 139 140 141 ... 469 470

Commentaires sur ces manuels

Pas de commentaire