Ford 2013 Fusion Hybrid v.1 Manuel d'utilisateur télécharger pdf (Page 59)

All personal codes are now erased and only

the factory set 5–digit code will work.

Anti-Scan Feature

The keypad will go into an anti-scan mode

if the wrong code has been entered seven

times (35 consecutive button presses).

This mode disables the keypad for one

minute and the keypad lamp will flash.

The anti-scan feature will turn off after:

• one minute of keypad inactivity

• pressing the unlock button on the

remote control

• the ignition is switched on

• unlocking the vehicle using intelligent

access (if equipped).

Unlocking and Locking the Doors

To Unlock the Driver’s Door

Enter the factory set 5-digit code or your

personal code. Each number must be

pressed within five seconds of each other.

The interior lamps will illuminate.

Note: All doors will unlock if the all door

unlocking mode is enabled. See Locking

and Unlocking (page 52).

To Unlock All Doors

Enter the factory set code or your personal

code, then press 3·4 within five seconds.

To Lock All Doors

Press and hold 7·8 and 9·0 at the same

time (with the driver’s door closed). You

do not need to enter the keypad code first.

To Release the Trunk

Enter the factory set code or your personal

code, then press 5·6 within five seconds.

Displaying the Factory Set Code

With Integrated Keyhead Transmitters

Note: You will need to have two

programmed passive anti-theft keys for this

procedure.

To display the factory set code in the

information display:

1. Insert a key into the ignition and turn

the ignition on for a few seconds.

2. Turn the ignition off and remove the

key.

3. Insert the second key into the ignition

and turn the ignition on.

The factory set code will display for a few

seconds.

Note: The code may not display until after

any other warning messages first display.

With Intelligent Access Keys

Note: You will need to have two

programmed intelligent access keys for this

procedure.

To display the factory set code in the

information display:

1. Place the first programmed key in the

backup slot inside the center console.

2. Press the START/STOP button once

and wait a few seconds.

3. Press the START/STOP button again

and remove the key.

4. Insert the second programmed key into

the backup slot, then press the

START/STOP button.

The factory set code will appear in the

information display for a few seconds.

Note: The code may not display until after

any other warning messages first display.

57

Locks

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 460 461

Commentaires sur ces manuels

Pas de commentaire