Ford 2013 Fusion Hybrid v.1 Manuel d'utilisateur télécharger pdf (Page 255)

3. Keep both pedals fully pressed.

4. After three seconds, the Service: Oil

reset in prog. message will be

displayed.

5. After 25 seconds, the Service: Oil reset

complete message will be displayed.

6. Release both the accelerator and brake

pedals.

7. The Service: Oil reset complete

message will no longer be displayed.

8. Rotate the key to the off position. For

vehicles with push-button start, press

the start button to turn the vehicle off

completely.

Oil Maintenance Mode (If Equipped)

The oil maintenance mode is equipped on

Energi models only. The oil maintenance

mode keeps the engine oil quality in good

condition when you drive the vehicle with

limited engine use. If the vehicle is in oil

maintenance mode when you start the

vehicle, a message will appear in the

instrument cluster. While the vehicle is in

oil maintenance mode, the vehicle will run

the engine as necessary.

If you select the EV Now mode while the

vehicle is in the oil maintenance mode, the

oil maintenance mode will be suspended

for as long as you continue driving the

vehicle. The oil maintenance mode will

resume the next time you start the vehicle.

Changing the engine oil and resetting the

oil life monitoring system will suspend the

oil maintenance mode.

ENGINE COOLANT CHECK -

2.0L HYBRID

Engine Coolant and Inverter

System Controller Coolant

Your vehicle is equipped with two separate

cooling systems. One is for cooling the

engine and one is for cooling the inverter

system controller that is specific to the

hybrid operating system. The two systems

operate similarly, with the inverter system

controller cooling system generally

operating at a lower temperature and

pressure.

Checking the Engine Coolant

When the engine is cold, check the

concentration and level of the engine

coolant at the intervals listed in the

scheduled maintenance information. See

Scheduled Maintenance (page 430).

Note: Make sure that the level is between

the MIN and MAX marks on the engine

coolant reservoir.

Note: Coolant expands when it is hot. The

level may extend beyond the MAX mark.

Note: If the level is at the MIN mark, below

the MIN mark, or empty, add prediluted

coolant immediately. See Adding Engine

Coolant in this chapter.

The coolant concentration should be

maintained at 50%.

Note: For best results, coolant

concentration should be tested with a

refractometer such as Rotunda tool

ROB75240 available from your dealer. Ford

does not recommend the use of

hydrometers or coolant test strips for

measuring coolant concentrations.

253

Maintenance

1 2 ... 250 251 252 253 254 255 256 257 258 259 260 ... 460 461

Commentaires sur ces manuels

Pas de commentaire