Ford 2013 Expedition v.3 Manuel d'utilisateur télécharger pdf (Page 188)

100

101

Fixed Code Programming

Note: It may be helpful to have another person assist you in

programming the transmitter.

To program units with fixed code

DIP switches, you will need the

garage door hand-held transmitter,

paper and a pen or pencil.

1. Switch the ignition on.

2. Open the battery cover and note

all the switch settings from left to

right.

When the switch is in the up, on, or + position, mark down “left button”.

When the switch is in the middle, neutral, or 0 position, mark down

“middle button”.

When the switch is in the down, off, or – position, mark down “right

button”.

3. Press all three function buttons

simultaneously for a few seconds

and then release. The LED lamps

will flash slowly.

Note: The following step must be

completed within 2.5 minutes.

4. Enter the corresponding DIP

switch settings from left to right

into the system by pressing and releasing the buttons corresponding to

the settings you noted.

5. Simultaneously press and release all three function buttons. The LED

lamps will illuminate.

6. Press and hold the function

button you would like to use to

control the garage door.

Note: You may need to hold the

button from 5–55 seconds before

observing movement of the garage

door.

7. When the garage door moves, release the button within one second.

When the button is released, the LED lamp will flash slowly.

Universal Garage Door Opener (If Equipped) 187

2013 Expedition (exd)

Owners Guide gf, 3rd Printing, April 2013

USA (fus)

1 2 ... 183 184 185 186 187 188 189 190 191 192 193 ... 514 515

Commentaires sur ces manuels

Pas de commentaire

Ford 2013 Expedition v.3 Manuel d'utilisateur Page 188

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Ford 2013 Expedition v.3