Ford 2009 Explorer Sport Trac v.2 Manuel d'utilisateur télécharger pdf (Page 126)

2. Do not wipe off any grease on the

battery terminals on the back

surface of the circuit board.

3. Remove the old battery.

Note: Please refer to local

regulations when disposing of

transmitter batteries.

4. Insert the new battery. Refer to

the diagram inside the remote entry

transmitter for the correct

orientation of the battery. Press the battery down to ensure that the

battery is fully seated in the battery housing cavity.

5. Snap the two halves back together.

Note: Replacement of the battery will not cause the remote transmitter

to become deprogrammed from your vehicle. The remote transmitter

should operate normally after battery replacement.

Replacing lost remote entry transmitters

If you would like to have your remote entry transmitter reprogrammed

because you lost one, or would like to buy additional remote entry

transmitters, you can either reprogram them yourself, or take all

remote entry transmitters to your authorized dealer for

reprogramming.

How to reprogram your remote entry transmitters

You must have all remote entry transmitters (maximum of six)

available before beginning this procedure. If all remote entry transmitters

are not present during the programming procedure, the transmitters that

are not present during programming will no longer operate the vehicle.

Note: Ensure the brake pedal is not depressed during this sequence.

To reprogram the remote entry transmitters:

1. Ensure the vehicle is electronically unlocked.

2. Put the key in the ignition.

2009 07+ Explorer Sport Trac (esp)

Owners Guide, 2nd Printing

USA (fus)

Locks and Security

126

1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 350 351

Pas de commentaire

Ford 2009 Explorer Sport Trac v.2 Manuel d'utilisateur Page 126