Ford 2009 Explorer Sport Trac v.1 Manuel d'utilisateur télécharger pdf (Page 181)

Installing child safety seats with combination lap and shoulder

belts

If needed, when installing some high back child restraints, the head

restraints of the second row seating positions can be removed. Insert a

thin pointed object, such as a paper clip or pushpin, into the hole of

each head restraint guide and while lifting up remove the head restraint.

Store the head restraint in a secure location in the vehicle. To re-install

the head restraint, line the posts up in the holes on the seat back with

the head restraint strap facing the outside of the vehicle and push down

until the head restraint locks into place. Lift gently to ensure it is locked

into place.

Refer to Safety seats for children later in this chapter.

WARNING: If the head restraint has been removed from a

seating position to accommodate a high back child restraint, the

head restraint must be re-installed prior to use of the seat by any other

occupant in order to reduce the risk of personal injury in the event of

a collision.

Check to make sure the child seat is properly secured before each use.

Children 12 and under should be properly restrained in a rear seating

position whenever possible. If all children cannot be seated and

restrained properly in a rear seating position, properly restrain the

largest child in the front seat.

When installing a child safety seat with combination lap/shoulder belts:

• Use the correct safety belt buckle for that seating position.

• Insert the belt tongue into the proper buckle until you hear a snap

and feel it latch. Make sure the tongue is securely fastened in the

buckle.

2009 07+ Explorer Sport Trac (esp)

Owners Guide, 1st Printing

USA (fus)

Seating and Safety Restraints

181

1 2 ... 176 177 178 179 180 181 182 183 184 185 186 ... 355 356

Pas de commentaire

Ford 2009 Explorer Sport Trac v.1 Manuel d'utilisateur Page 181