Ford 2003 Ranger Manuel d'utilisateur télécharger pdf (Page 84)

One time disable

Any time the safety belt is buckled and then unbuckled during an

ignition ON cycle, the BeltMinder will be disabled for that ignition cycle

only.

Deactivating/activating the BeltMinder feature

Read steps1-9thoroughly before proceeding with the

deactivation/activation programming procedure.

The BeltMinder feature can be deactivated/activated by performing the

following procedure:

Before following the procedure, ensure that the following conditions are

met:

• The parking brake is set.

• The gearshift is in P (Park) (automatic transmission) or the neutral

position (manual transmission).

• The ignition switch is in the OFF position.

• All vehicle doors are closed.

• The driver’s safety belt is unbuckled.

• The parklamps/headlamps are in OFF position (If vehicle is equipped

with Autolamps, this will not affect the procedure).

To reduce the risk of injury, do not deactivate/activate the Belt

Minder feature while driving the vehicle.

BeltMinder activation and deactivation procedure

1. Turn the ignition switch to the RUN (or ON) position. (DO NOT

START THE ENGINE.)

2. Wait until the safety belt warning light turns off. (Approximately 1–2

minutes.)

• Steps 3–5 must be completed within 60 seconds or the procedure will

have to be repeated.

3. Buckle then unbuckle the safety belt three times, ending with the

safety belt unbuckled. This can be done before or during BeltMinder

warning activation.

4. Turn on the parklamps/headlamps, turn off the parklamps/headlamps.

5. Buckle then unbuckle the safety belt three times, ending with the

safety belt unbuckled.

Seating and Safety Restraints

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 255 256

Pas de commentaire

Ford 2003 Ranger Manuel d'utilisateur Page 84