Ford 2002 F-150 Manuel d'utilisateur télécharger pdf (Page 155)

• Rear seats (SuperCrew only)

If the tether strap is clipped

incorrectly, the child safety

seat may not be retained properly

in the event of a collision.

5. Refer to the Installing child

safety seats in combination lap

and shoulder belt seating

positions section of this chapter for

further instructions to secure the

child safety seat.

6. Tighten the child safety seat

tether strap according to the

manufacturer’s instructions.

If the safety seat is not anchored properly, the risk of a child

being injured in a collision greatly increases.

Tether strap attachment rear SuperCab only

There are three loops of webbing just above the back of the rear seat

(along the bottom edge of the rear window) in the SuperCab. These

loops are to be used as both routing loops and anchor loops for child

safety seat tether straps. For example, the center loop can be used as a

routing loop for a child safety seat in the center rear seat and as an

anchoring loop for child seats installed in the outboard rear seats.

Many tether straps cannot be tightened if the tether strap is hooked to

the loop directly behind the child seat. To provide a tight tether strap:

Seating and Safety Restraints

155

1 2 ... 150 151 152 153 154 155 156 157 158 159 160 ... 311 312

Pas de commentaire

Ford 2002 F-150 Manuel d'utilisateur Page 155