Ford 1999 Crown Victoria Manuel d'utilisateur télécharger pdf (Page 180)

2. Install the bulb retaining ring over the plastic base until it contacts the

rear of the socket by rotating it clockwise until you feel a “stop.”

3. Connect the electrical connector into the rear of the plastic base until

it snaps, locking it into position.

4. Install the protective cover over headlamps locking it in place with

three knobs.

5. Turn the headlamps on and make sure they work properly. If the

headlamp was correctly aligned before you changed the bulb, you should

not need to align it again.

Replacing front parking lamp/turn signal bulbs

1. Make sure headlamp switch is in OFF position, then open the hood.

2. Remove the protective cover by turning the three knobs to the unlock

position.

3. Disengage the safety snap on the connector by pulling upward slightly

on the clip.

4. Disconnect the electrical

connector from the bulb socket.

5. Rotate the bulb socket

counterclockwise about

⁄

turn and

remove from lamp assembly.

6. Carefully pull bulb straight out of the socket and push in the new

bulb.

7. To complete installation, follow the removal procedure in reverse

order.

Maintenance and care

180

1 2 ... 175 176 177 178 179 180 181 182 183 184 185 ... 207 208

Pas de commentaire

Ford 1999 Crown Victoria Manuel d'utilisateur Page 180