Ford 2015 Escape Manuel d'utilisateur télécharger pdf (Page 227)

E142467

5. Locate the vertical adjuster on each

headlamp. Using a Phillips #2

screwdriver, turn the adjuster either

clockwise or counterclockwise in order

to aim the headlamp.

6. Close the hood and turn off the lamps.

Horizontal Aim Adjustment

Horizontal aim is not required for this

vehicle and is non-adjustable.

REMOVING A HEADLAMP

2

2

E142468

1. Make sure the headlamp control is in

the off position and open the hood.

2. Remove the two screws from the

headlamp assembly.

3. Carefully pull the headlamp assembly

as far as possible towards the front of

the vehicle to disengage it from the

lower fixing point.

4. Carefully lift the outer side of the

headlamp and remove it.

5. Disconnect the electrical connector.

CHANGING A BULB

Lamp Assembly Condensation

Exterior lamps are vented to

accommodate normal changes in pressure.

Condensation can be a natural by-product

of this design. When moist air enters the

lamp assembly through the vents, there is

a possibility that condensation can occur

when the temperature is cold. When

normal condensation occurs, a thin film of

mist can form on the interior of the lens.

The thin mist eventually clears and exits

through the vents during normal operation.

Clearing time may take as long as 48 hours

under dry weather conditions.

Examples of acceptable condensation are:

• Presence of thin mist (no streaks, drip

marks or droplets).

• Fine mist covers less than 50% of the

lens.

Examples of unacceptable moisture

(usually caused by a lamp water leak) are:

• Water puddle inside the lamp.

• Large water droplets, drip marks or

streaks present on the interior of the

lens.

Take your vehicle to a dealer for service if

any of the above conditions of

unacceptable moisture are present.

224

Escape (TM2), enUSA, First Printing

Maintenance

1 2 ... 222 223 224 225 226 227 228 229 230 231 232 ... 448 449

Commentaires sur ces manuels

Pas de commentaire