Ford 2014 Taurus v.2 Manuel d'utilisateur télécharger pdf (Page 348)

100

101

7. Push and turn dial (A)

counterclockwise to the sealant

position. Turn on the kit by pressing

the on button (B).

8. Inflate the tire to the pressure

listed on the Tire Label located on

the driver’s door or the door jamb

area.

Note: When the sealing compound is first added into the tire, the air

pressure gauge reading on the compressor unit may indicate a higher

value; this is normal and should be no reason for concern. The pressure

will drop after about 30 seconds of operation. The tire pressure has to be

checked with the compressor in the OFF position to get the correct tire

pressure reading.

9. When the recommended tire pressure is reached, turn off the kit by

pressing the on and off button, then disconnect the kit from the tire

valve and the power point. Re-install the valve cap on the tire valve,

place the tube cap on the metal connector, and return the kit to the

stowage area.

10. Note: Immediately and cautiously, drive the vehicle 4 miles

(6 kilometers) to distribute the sealant evenly inside the tire. Do not

exceed 50 mph (80 km/h).

Note: If you experience any unusual vibration, ride disturbance or

noise while driving, reduce your speed until you can safely pull off to

the side of the road to call for roadside assistance. Note: Do not

proceed to the second stage of this operation.

11. After 4 miles (6 kilometers), stop and check the tire pressure.

See Second Stage: Checking Tire Pressure.

Wheels and Tires 347

2014 Taurus

Owners Guide gf, 2nd Printing, September 2013

USA (fus)

1 2 ... 343 344 345 346 347 348 349 350 351 352 353 ... 553 554

Commentaires sur ces manuels

Pas de commentaire

Ford 2014 Taurus v.2 Manuel d'utilisateur Page 348

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Ford 2014 Taurus v.2