Ford 2014 Fusion v.2 Manuel d'utilisateur télécharger pdf (Page 48)

1. Insert the key blade into the slot on the

bottom of the handle and press up.

2. While maintaining upward pressure,

move the cap rearward to release it.

Gently remove the key while doing so.

To install the cap:

E151957

1. Place the cap just forward of the key

cylinder.

2. While applying pressure to the cap,

move it forward until it is in place. You

may hear a snap as it engages.

Make sure you have properly installed the

cap by trying to move it rearward.

Replacing the Battery

Note: Refer to local regulations when

disposing of transmitter batteries.

Note: Do not wipe off any grease on the

battery terminals or on the back surface of

the circuit board.

Note: Replacing the battery will not delete

the transmitter from the vehicle. The

transmitter should operate normally.

A message will appear in the information

display when the remote control battery

is low. See Information Messages (page

94).

Integrated Keyhead Transmitter

The remote control uses one coin-type

three-volt lithium battery CR2032 or

equivalent.

Press the button to release the key before

beginning the procedure.

E151798

1. Insert a screwdriver in the position

shown and gently push the clip.

2. Press the clip down to release the

battery cover.

E151799

3. Carefully remove the cover.

46

Fusion (CC7)

Keys and Remote Controls

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 452 453

Commentaires sur ces manuels

Pas de commentaire