Ford 2014 Expedition v.3 Manuel d'utilisateur télécharger pdf (Page 287)

100

101

5. Locate the vertical adjuster on

each headlamp, then use a Phillips

#2 screwdriver to turn the adjuster

either counterclockwise or

clockwise in order to adjust the

vertical aim of the headlamp.

The upper edge of the light pattern

should line up to the horizontal line.

6. Repeat Steps 3–5 for the other

headlamp.

7. Close the hood and turn off the lamps.

HORIZONTAL AIM IS NOT REQUIRED FOR THIS VEHICLE AND IS

NOT ADJUSTABLE.

CHANGING A BULB

Lamp Assembly Condensation

Exterior lamps are vented to accommodate normal changes in pressure.

Condensation can be a natural by-product of this design. When moist air

enters the lamp assembly through the vents, there is a possibility that

condensation can occur when the temperature is cold. When normal

condensation occurs, a thin film of mist can form on the interior of the

lens. The thin mist eventually clears and exits through the vents during

normal operation. Clearing time may take as long as 48 hours under dry

weather conditions.

These are examples of acceptable condensation:

• Presence of thin mist (no streaks, drip marks or droplets).

• Fine mist covers less than 50% of the lens.

These are examples of unacceptable moisture (usually caused by a lamp

water leak):

• Water puddle inside the lamp.

• Large water droplets, drip marks or streaks present on the interior of

the lens.

Take your vehicle to a dealer for service if any of the above conditions of

unacceptable moisture are present.

286 Maintenance

2014 Expedition (exd)

Owners Guide gf, 3rd Printing, March 2014

USA (fus)

1 2 ... 282 283 284 285 286 287 288 289 290 291 292 ... 519 520

Commentaires sur ces manuels

Pas de commentaire

Ford 2014 Expedition v.3 Manuel d'utilisateur Page 287

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Ford 2014 Expedition v.3