Ford 2014 Escape v.3 Manuel d'utilisateur télécharger pdf (Page 122)

E142660

1. Press and hold the outer two function

buttons simultaneously for

approximately 20 seconds until the

indicator lights above the buttons flash

rapidly.

2. When the indicator lights flash, release

the buttons. The codes for all buttons

are erased.

Reprogramming a Single Button

To program a device to a previously trained

button, follow these steps:

1. Press and hold the desired button. Do

NOT release the button.

2. The indicator light will begin to flash

after 20 seconds. Without releasing the

button, follow Step 1 in the

Programming section.

For questions or comments, contact

HomeLink at www.homelink.com or

1-800-355-3515.

Programming to a Genie Intellicode 2

Garage Door Opener

Note: The Genie Intellicode 2 transmitter

must already be programmed to operate

with the garage door opener.

Note: To program HomeLink to the

transmitter you must first put the

transmitter into programming mode.

BA

E142661

Red indicator lightA.

Green indicator lightB.

1. Press and hold one of the buttons on

the hand-held transmitter for 10

seconds. The indicator light will change

from green to red and green.

2. Press the same button twice to confirm

the change to programming mode. If

done properly the indicator light will

appear red.

3. Hold the transmitter within 1–3 inches

(2–8 centimeters) of the button on the

visor you want to program.

4. Press and hold both the programmed

Genie button on the hand-held

transmitter and the button you want

to program. The indicator light on the

visor will flash rapidly when the

programming is successful.

Note: The Genie transmitter will transmit

for up to 30 seconds. If HomeLink does not

program within 30 seconds the Genie

transmitter will need to be pressed again. If

the Genie transmitter indicator light displays

green and red, release the button until the

indicator light turns off before pressing the

button again.

Once HomeLink has been programmed

successfully, the Genie transmitter must

be changed out of program mode. To do

this:

119

Escape (TM2)

Universal Garage Door Opener (If Equipped)

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 433 434

Commentaires sur ces manuels

Pas de commentaire