Ford 2014 Escape v.2 Manuel d'utilisateur télécharger pdf (Page 223)

6. Wipe any dirt or debris from the air filter

housing and cover to make sure no dirt

gets in the engine and to make sure you

have a good seal.

7. Slide the open end of the air filter

element in first, below the tab. Then

push the closed end cap into the

bottom of the tray. The closed end cap

should fit inside the groove in the tray.

The tab at the end of the closed end

cap should be oriented down and fit

between the forks on the tray.

8. Replace the air filter housing cover and

secure the clips.

9. Reinstall the air cleaner assembly into

the vehicle.

10. Reinstall the clean air tube assembly

into the air cleaner assembly.

11. Tighten the air tube fastening screws.

ADJUSTING THE HEADLAMPS

Vertical Aim Adjustment

The headlamps on your vehicle are

properly aimed at the assembly plant. If

your vehicle has been in an accident, the

alignment of your headlamps should be

checked by your authorized dealer.

E142592

8 feet (2.4 meters)A

Center height of lamp to groundB

25 feet (7.6 meters)C

Horizontal reference lineD

Vehicles With Halogen Headlamps

1. Park the vehicle directly in front of a

wall or screen on a level surface,

approximately 25 feet (7.6 meters)

away.

2. Measure the height of the headlamp

bulb center from the ground and mark

an 8 foot (2.4 meter) horizontal

reference line on the vertical wall or

screen at this height.

Note: To see a clearer light pattern for

adjusting, you may want to block the light

from one headlamp while adjusting the

other.

3. Turn on the low beam headlamps to

illuminate the wall or screen and open

the hood.

E142465

4. On the wall or screen you will observe

a flat zone of high intensity light

located at the top of the right hand

portion of the beam pattern. If the top

edge of the high intensity light zone is

not at the horizontal reference line, the

headlamp will need to be adjusted.

220

Escape/Kuga (TM2)

Maintenance

1 2 ... 218 219 220 221 222 223 224 225 226 227 228 ... 429 430

Commentaires sur ces manuels

Pas de commentaire