Ford 2013 Explorer v.3 Manuel d'utilisateur Page 84

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 579
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 83
You may also program a personal entry code through the MyFord Touch
or MyLincoln Touch system (if equipped). Refer to the MyFord Touch or
MyLincoln Touch chapter.
Tips:
Do not set a code that uses five of the same number.
Do not use five numbers in sequential order.
The factory set code will work even if you have set your own personal
code.
Erasing a Personal Code
1. Enter the factory set 5-digit code.
2. Press and release the 12 on the keypad within five seconds.
3. Press and hold the 12 for two seconds. This must be done within
five seconds of completing Step 2.
All personal codes are now erased and only the factory set 5- digit code
will work.
Anti-Scan Feature
The keypad will go into an anti-scan mode if the wrong code has been
entered seven times (35 consecutive button presses). This mode disables
the keypad for one minute and the keypad lamp will flash.
The anti-scan feature will turn off after:
one minute of keypad inactivity
pressing the unlock button on the remote control
the ignition is turned on
unlocking the vehicle using intelligent access (if equipped)
Unlocking and Locking the Doors
To unlock the driver’s door: enter the factory set 5-digit code or your
personal code. Each number must be pressed within five seconds of each
other. The interior lamps will illuminate. Note: All doors will unlock if
the two-stage unlocking feature is disabled. Refer to Locking and
Unlocking earlier in this chapter.
To unlock all doors: enter the factory set code or your personal code,
then press the 34 control within five seconds.
To lock all doors: press and hold 78 and 90 at the same time (with
the driver’s door closed). You do not need to enter the keypad code first.
Locks 83
2013 Explorer (exp)
Owners Guide gf, 3rd Printing
USA (fus)
Vue de la page 83
1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 578 579

Commentaires sur ces manuels

Pas de commentaire