Ford 2012 Taurus v.2 Manuel d'utilisateur télécharger pdf (Page 115)

Deactivating/activating autolock feature

Your vehicle comes with the autolock features activated; there are three

methods to enable/disable this feature:

• Through your authorized dealer,

• by using a power door unlock/lock procedure, or

• by using the instrument cluster message center. Refer to Message

center in the Instrument Cluster chapter.

Note: The autolock feature can be activated/deactivated independently

of the autounlock feature.

Power door lock switch autolock enable/disable procedure

Before starting, ensure the ignition is off and all vehicle doors are closed.

You must complete Steps 1–5 within 30 seconds or the procedure will

have to be repeated. If the procedure needs to be repeated, wait a

minimum of 30 seconds before beginning again.

1. Turn the ignition on.

2. Press the power door unlock

control on the door panel three

times.

3. Turn the ignition off.

4. Press the power door unlock

control on the door panel three

times.

5. Turn the ignition back on. The horn will chirp one time to confirm

programming mode has been entered and is active.

6. To enable/disable the autolock feature, press the unlock control, then

press the lock control. The horn will chirp once if autolock was

deactivated or twice (one short and one long chirp) if autolock was

activated.

7. Turn the ignition off. The horn will chirp once to confirm the

procedure is complete.

Autounlock feature (if enabled)

The autounlock feature will unlock all the doors when:

• the ignition is on, all the doors are closed, and the vehicle has been in

motion at a speed greater than 12 mph (20 km/h);

• the vehicle has then come to a stop and the ignition is turned off or to

accessory; and

Locks and Security

115

2012 Taurus

Owners Guide, 2nd Printing

USA (fus)

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 405 406

Pas de commentaire

Ford 2012 Taurus v.2 Manuel d'utilisateur Page 115