Ford 2012 Taurus v.1 Manuel d'utilisateur télécharger pdf (Page 362)

Adjusting automatic transmission fluid levels

Before adding any fluid, make sure the correct type is used. The type of

fluid used is normally indicated on the dipstick and also in the

Maintenance product specifications and capacities section in this

chapter.

Use of a non-approved automatic transmission fluid may cause

internal transmission component damage.

If necessary, add fluid in 1/2 pint

(250 ml) increments through the

filler tube until the level is correct.

If an overfill occurs, excess fluid

should be removed by an authorized

dealer.

An overfill condition of

transmission fluid may cause shift and/or engagement concerns

and/or possible damage.

Do not use supplemental transmission fluid additives, treatments or

cleaning agents. The use of these materials may affect transmission

operation and result in damage to internal transmission components.

For vehicles equipped with the EcoBoost engine, reinstall the air

filter assembly.

After the fluid level has been checked and adjusted as necessary, do the

following:

A. Shut the engine off.

B. Loosen the clamp holding the air filter assembly to the rubber hose.

C. Rotate the air filter assembly 90 degrees clockwise without

disconnecting the sensor.

D. Seat the air filter assembly back into the grommets by pushing down

on the air filter assembly.

E. Tighten the clamp.

F. Install and tighten two bolts that attach air filter assembly to the front

of the vehicle.

G. Install the bolt cover (if equipped).

H. Reinstall the harness retaining clip into the front of the air filter

assembly.

MAX

MIN

Maintenance and Specifications

362

2012 Taurus

Owners Guide, 1st Printing

USA (fus)

1 2 ... 357 358 359 360 361 362 363 364 365 366 367 ... 405 406

Pas de commentaire

Ford 2012 Taurus v.1 Manuel d'utilisateur Page 362