Ford 2012 Focus v.3 Manuel d'utilisateur Page 172

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 404
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 171
9. Remove the newly programmed coded key from the ignition.
If the key has been successfully programmed it will start the vehicle’s
engine and will operate the remote entry system (if the new key is an
integrated keyhead transmitter).
If the key was not successfully programmed, it will not start your
vehicle’s engine and/or will not operate the remote entry features. The
message center will display: NO KEY DETECTED. Wait 10 seconds and
you may repeat Steps 1 through 8. If failure repeats, bring your vehicle
to your authorized dealer to have the new key(s) programmed.
To program additional new unprogrammed key(s), wait 20 seconds and
then repeat this procedure from Step 1.
Note: To program MyKey features, refer to MyKey in this chapter.
Programming spare intelligent access keys (if equipped)
If you have integrated keyhead transmitters (IKT) or standard
SecuriLock coded keys, refer to Programming spare integrated
keyhead transmitter (IKT) keys in this section.
If you would like to have additional intelligent access keys programmed
to your vehicle, please contact your authorized dealer.
Note: To program MyKey features, refer to MyKey in this chapter.
PERIMETER ALARM SYSTEM (IF EQUIPPED)
The perimeter anti-theft system will warn you in the event of an
unauthorized entry to your vehicle.
If there is any potential perimeter anti-theft problem with your vehicle,
ensure ALL remote entry transmitters are taken to the authorized
dealer to aid in troubleshooting.
Arming the system
When armed, this system will respond if unauthorized entry is
attempted. When unauthorized entry occurs, the system will flash the
park/turn lamps and will sound the horn.
The system is ready to arm whenever the key is removed from the
ignition. Either of the following actions will prearm the alarm system:
Press the lock control on the remote entry transmitter.
Open a door and press the power door lock control to lock all the
doors, and then close the door.
Locks and Security
171
2012 Focus (foc)
Owners Guide, 3rd Printing
USA (fus)
Vue de la page 171
1 2 ... 167 168 169 170 171 172 173 174 175 176 177 ... 403 404

Commentaires sur ces manuels

Pas de commentaire