Ford 2011 Fusion v.3 Manuel d'utilisateur télécharger pdf (Page 173)

The rear seats of your vehicle are equipped with built-in tether strap

anchors located behind the seats as described below.

The tether anchors in your vehicle are located under a cover marked

with the tether anchor symbol (shown with title).

The tether strap anchors in your

vehicle are in the following positions

(shown from top view):

Attach the tether strap only to the appropriate tether anchor as shown.

The tether strap may not work properly if attached somewhere other

than the correct tether anchor.

Once the child safety seat has been installed, using either the safety belt,

the lower anchors of the LATCH system, or both, you can attach the top

tether strap.

If you install a child seat with rigid LATCH attachments, and have

attached the top tether strap to the proper top tether anchor, do not

tighten the tether strap enough to lift the child seat off the vehicle seat

cushion when the child is seated in it. Keep the tether strap just snug

without lifting the front of the child seat. Keeping the child seat just

touching the vehicle seat gives the best protection in a severe crash.

Perform the following steps to attach a child safety seat to the tether

anchor:

1. Route the child safety seat tether strap over the back of the seat.

For outboard seating positions, route the tether strap under the head

restraint and between the head restraint posts. For the center seating

position, route the tether strap over the top of the head restraint.

Seating and Safety Restraints

173

2011 Fusion (fsn)

Owners Guide, 3rd Printing

USA (fus)

1 2 ... 168 169 170 171 172 173 174 175 176 177 178 ... 373 374

Pas de commentaire

Ford 2011 Fusion v.3 Manuel d'utilisateur Page 173