Ford 2011 Fusion v.2 Manuel d'utilisateur télécharger pdf (Page 223)

If the fuse is not blown and the brake lamps are working properly, the

following procedure will allow you to move the gearshift lever from P

(Park):

1. Apply the parking brake, turn the

ignition key to the off position, and

remove the key.

2. Using a screwdriver (or similar

tool), carefully pry off and remove

the chrome trim ring (1) from the

shifter base.

3. Open the storage compartment

lid and carefully pry the trim panel

(2) up from rear attachments on the

storage compartment and disconnect it from the console to expose the

inside of the gearshift.

4. Locate the brake-shift interlock

lever on the driver’s side of the

shifter assembly.

5. Apply the brake pedal. Using a

screwdriver (or similar tool), press

and hold the brake-shift interlock

lever while pulling the gearshift

lever out of the P (Park) position

and into the N (Neutral) position.

6. Install the trim panel (2) and

chrome ring (1) in reverse order.

7. Apply brake pedal, start the vehicle, and release the parking brake.

See your authorized dealer as soon as possible if this procedure

is used.

WARNING: Do not drive your vehicle until you verify that the

brake lamps are working.

WARNING: Always set the parking brake fully and make sure

the gearshift is latched in P (Park). Turn the ignition to the off

position and remove the key whenever you leave your vehicle.

Driving

223

2011 Fusion (fsn)

Owners Guide, 2nd Printing

USA (fus)

1 2 ... 218 219 220 221 222 223 224 225 226 227 228 ... 370 371

Pas de commentaire

Ford 2011 Fusion v.2 Manuel d'utilisateur Page 223